Contents Page Read this first.2 1.Check furnace location.
Prepare furnace and place in position.6 3. Connect supply and return ducts.8 4. Always apply whichever clearance is LARGER combustible Local, state, provincial, and national codes, laws, regulations and ordinances construction or service accessibility. NFPA-31, Installation of Oil-Burning Equipment Flooring and foundation National Electrical Code All local codes andor regulations take precedence over the. Williamson Company Oil Burner 02 689 Install A ReturnYou must install a return air duct, sealed to the furnace, even if no Remove access panels to inspect the furnace interior. This device is designed to detect the insufficient evacuation of combustion gases in the event of a vent blockage. The air pressure The temperature rise through the furnace must not exceed 85 F and loss through the cooling evaporator coil reduces should be at least 55. It can cause severe personal injury or death if power source, including the service switch on the furnace, is not disconnected before installation or servicing. Wire burner Connect power wiring The burner harness is factory-wired to the furnace. If there is no supply To successfully service the oil furnace, you must voltage, check fuses and service switch. CAUTION: have these instruments: When testing electrical equipment, always follow smoke tester. Failure to perform the service and maintenance could result in damage to the furnace or system. Williamson Company Oil Burner 02 689 Manual And ComponentFailure to follow the directions in this manual and component literature could result in severe personal injury, death or substantial property damage. Ceramic fiber can be converted to cristobalite in very high temperature applications. The International Agency for Research on Cancer (IARC) has concluded, Crystalline silica inhaled in the form of quartz or cristobalite from occupational sources is carcinogenic to humans (Group 1). If the thermal switch is drive blower motor as they are permanently damaged, replacement is required. A Maximum Input Output Firing rate Blower speed cooling Blower CFM Installed. ![]() Failure to service and maintain the furnace and system could result in equipment failure, causing severe personal injury, death or substantial property damage.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |